• WinWarblerMultiRadioConfiguration

Configuring WinWarbler to Automatically Select Settings When a New Primary Radio is Selected in Commander

Commander can be configured to rapidly switch among four simultaneously-connected primary radio. You can configure WinWarbler to automatically update its settings in response to the selection of a new primary radio. To display WinWarbler's MultiRadio Configuration window, click the MultiRadio button along the bottom of the Configuration window's General tab. In the MultiRadio Configuration window,

1. on the General tab, uncheck the Enabled button

2. on the PTT tab, specify each primary radio's mode for RX-TX switching and, if required, the serial port to be used

3. on the Soundcard tab

   1. select the soundcard used for PSK & RTTY Reception by each primary radio

   2. select the soundcard used by 2Tone for RTTY reception by setting the Main window's Operating Mode panel to RTTY, and then repeating these steps for each primary radio:

      1. on the Configuration window's RTTY tab,

         • check the 2Tone panel's enabled box

         • click the 2Tone panel's 2Tone Setup button

      2. in the 2Tone Settings window's Receive Settings panel, select the soundcard to be used with the primary radio, and then click the OK button along the bottom of the window

      3. in the 2Tone Reception panel on WinWarbler's MultiConfiguration window's Soundcard tab, click the appropriate radio's Set but

   3. select the soundcard used for PSK & RTTY Transmission by each primary radio

   4. select the soundcard used for Phone Transmission by each primary radio

4. on the Startup Macros tab, specify a PSK, RTTY, CW, and Phone startup macro for each primary radio

5. on the PSK tab, specify the transceiver mode to be use for each primary radio when operating in PSK

6. on the RTTY tab, specify the Modulation, Transceiver Mode, Mark Offset, Optimal Offset, aand FSK Control to be used for each primary radio when operating in RTTY

7. on the CW tab, specify the Mode, Serial Port, and WinKey Output Ports to be used by each primary radio when operating in CW

8. on the Phone tab, specify the transceiver mode and Assert PTT settings to be use for each primary radio when operating in Phone

9. on the General tab, check the Enabled button

Post a question or suggestion on the DXLab Discussion Group

Getting Started with DXLab